Driving trolley line configuration introduction
Steel Plate & Coil,Inox Plate,Steel Coil,Steel Plate Coil TIANJIN YOUFA STEEL CO., LTD , https://www.cnyoufasteel.com
Driving trolley line configuration introduction:
Unipolar safety wire contact accessories configuration list:
Relevant fittings for use in unipolar trolley wires; collectors, shoe pieces (contact shoes, carbon brushes, blades), access sections, power input parts, joint jackets, aluminium fittings, end shields, single hole holders / Four-hole clamp, four-hole lifting pylon, single-hole lifting pylon, current collector bracket, temperature compensator (expansion section), among them, collector, maintenance section, and temperature compensator (expansion section) that require extra charge .
(1) How many meters are required for the trolley line?
Sliding line length = workshop length x three-wire/four-wire (If using a three-phase three-wire slide wire, multiply it by three. If using a three-phase four-wire slide wire, multiply by four).
(2) Number of trolley wires = Number of trolley wires ÷ 4.5/6 (Lightweight trolley wire is 4.5m, and heavy trolley wire is 6 meters long)
(3) Number of collectors = number of trips x three-wire / four-wire (If using a three-phase three-wire sled, multiply it by three, if using a three-phase four-wire sled, multiply by four).
(4) Current collector bracket = number of vehicles = number of current collectors
(5) Aluminium connector = trolley wire length ÷ 4.5/6
(6) Number of connector sheaths = number of aluminum connectors
(7) Light steel contact angle steel bracket = four-hole lifting rack = workshop length ÷ 1.2/1.5 (The angle of light bracket is generally 1.2m or 1.5m, and the heavy one is 3m. )
(8) Power Input = Line x Power Supply x Span
(9) Four hole clamps; one span 2 pieces
(10) Heavy-duty trolley wire angle bracket = workshop length ÷ 2.4/3 (2.4m or 3m angle bracket for heavy-duty trolley wire)
(11) single hole lifting bracket = angle bracket x-ray system (wire system is the three-phase three-phase three-wire, three-phase four-wire four-line)
(12) single hole clamp = wire x2x span
(13) End sheath = wire x2x span